Board 06 · Rescue
Refinishing: half of tired floors need a day, not a week. Know which half yours is in.
Refinishing is where homeowners are most often over-sold a full sanding for a floor that needed a recoat, or under-sold a recoat for a floor whose finish is already worn through to bare wood. The diagnosis is visual and takes a minute, once you know what you are looking at.
The diagnosis
- Screen and recoat is right when the finish is dull, scratched, and greyed in traffic lanes, but nowhere worn through to raw wood. The floor is abraded with a screen, cleaned, and given a fresh coat of finish. One day, modest cost, no dust storm, no stain change. It fails, and peels, if the old finish is contaminated with wax or silicone polishes, which is why honest refinishers ask what has been used on the floor and test a patch.
- Full sand and refinish is required when finish is worn through (grey, dry-looking wood that darkens when wet), when boards are stained deep (pet stains that have blackened the wood may sand out or may not), when the floor is cupped or uneven, or when you want a different colour. It is a multi-day job: rough, medium, and fine sanding passes, edging, screening, staining if chosen, then two to three coats of finish.
- Beyond refinishing: engineered floors with a veneer under about 2.5 mm, floors sanded many times until the tongue is near the surface, and boards with deep water damage or widespread splitting. Those are replacement or patch-and-blend conversations, and anyone who promises otherwise is selling, not refinishing.
Finishes and cure times
| Finish | Character | Use guidance |
|---|---|---|
| Water-based polyurethane | Clear, low odour, keeps pale wood pale | Light traffic in 24 hrs; rugs and heavy use after full cure, about 3–7 days by product |
| Oil-modified polyurethane | Amber warmth, traditional look | Slower; full cure can run to 30 days before rugs |
| Hardwax oil | Matte, spot-repairable, never peels | Needs periodic maintenance oil; a lifestyle choice, not a defect |
| Aluminium-oxide (factory) | The hardest common finish | Only on prefinished floors; recoating needs a bonding system |
All cure figures are typical ranges; the product on your floor sets the real ones, and the refinisher should leave them in writing.
Dust containment with vacuum-attached sanders is standard practice now, not an upgrade; a quote silent on dust is a quote from another decade. Expect furniture out, baseboards discussed (remove, or sand up to and accept the edger line), and a written statement of coats and product. That written scope is also what the connection desk asks a refinishing business to confirm.