Board 10 · After the install
After the install: care by material, in one place.
Care advice on this board used to live in a paragraph on each material's page. It is consolidated here because the rules contradict each other across materials — what hardwood wants, laminate forbids — and a household with three floors needs the whole table in one place.
The universal five
- Mats at every exterior door, inside and out. Grit is sandpaper with patience; most wear is tracked-in grit, not traffic itself.
- Felt pads on every furniture foot, replaced when they go thin. Chair legs are the highest-pressure contact in the house.
- Lift, never drag. A dragged appliance foot defeats every wear layer on this board.
- Sunlight rotates rugs and furniture a few times a year; every material here fades or mellows unevenly otherwise.
- Water is an event, not a cleaning method. Wipe spills when they happen, on every floor, whatever the brochure said about waterproofing.
Hardwood
Hold indoor humidity roughly 35–55% year-round; winter heating that drops a house below 30% is what opens the gaps owners blame on the installer. Clean with a dry or barely-damp mop and a cleaner made for the finish — not steam, which forces moisture into the joints and is excluded by most finish warranties, and not vinegar solutions, which dull polyurethane over time. When traffic lanes lose their sheen while the rest of the floor is sound, that is a screen-and-recoat conversation (see refinishing), not a full sanding — catching it before the finish wears through to bare wood is the cheapest decision in hardwood ownership.
Vinyl plank and sheet vinyl
Damp-mop with a pH-neutral cleaner; skip wax and "shine" products entirely — they build a film that dulls, holds dirt, and has to be stripped. No steam mops: heat plus moisture at the joints is the combination manufacturers exclude. Use wide furniture glides under heavy pieces, because vinyl dents under point loads and a dent is permanent. Sheet vinyl asks the same, plus care at seams and the perimeter, where water that gets under the sheet is the one real failure mode.
Laminate
The wear layer is nearly maintenance-free and the joints are the weakness, so the rule is a well-wrung mop and no standing water, ever. No steam, no wax, no oil soaps. A swollen joint from a one-off flood is not cleanable back to flat; prevention is the whole game, as the laminate board says plainly.
Tile, stone, and grout
The tile face needs little; the grout is the maintenance item. Cement grout is porous and wants resealing on a cycle of a year or two in wet areas; epoxy grout largely does not. Clean with pH-neutral products — acids etch stone and eat cement grout, and the "deep clean" that brightens grout with acid is spending the grout to clean it. Natural stone wants its own sealer schedule; the tile & stone board carries the detail.
Carpet
Vacuum traffic lanes twice a week and the whole floor weekly — grit at the pile base is what cuts fibres, and it is a cutting problem, not a dirt problem. Blot spills, never scrub them into a bloom. A professional hot-water extraction every 12–18 months is the interval most carpet warranties actually name; keep the receipts, because some warranties make that clean a condition. The carpet board covers fibre choice if replacement is on the horizon.